Wireless Electric Dog Fence Pet Containment System Shock Collars For 1 2 3 Dogs

  

Full set for Three Dogs Package included. Full set for Two Dogs Package included. Full set for One Dogs Package included.

Only 6 rubber buckle screwdriver. Charging: Be sure to use the original charging plug. When charging, the green light will flash. When the battery is fully charged, the green light will be on. It will be fully charged after 2-3 hours of charging.

The battery 3.7 volt lithium battery 400MA can be recharged 500 times. Weak current prompt: When the receiver's power is lower than 3 volts, the receiver red indicator will flash, indicating charging. When bringing a new dog to the household, it's key that it knows its limits. Pet fence system offers the easiest and quickest way to train your dog to the ways of your home with a large selection of electronic collars.

Our e-collars combine sophisticated technology with durability so your new pet can still enjoy the fun rough and tumble playtime with your family. The harmless radio signal was issued by transmitter and go through the wire to be boundary of the "yard". The closer your dog gets to the boundary, the more intense the shock will be.

A warning tone will be issued twice and then a shock stimulus if your dog continues to move closer to the boundary. Allows you to precisely control the width of the signal field.

Audible and Visual Wire Break Indicators. Once the buried wire was broke, a loud sonic alarm will issue with a flashing light. The faster your dog is moving, and the higher level of intensity is issued. Add as many collars as you like to contain as many animals you have. There is no limit to the number of collars it can control.

Up to 2500/5000 square meters range(over 1.24 acre). Reflective Strap Fluorescent TPU, Increase night safety.

To make sure the fence system can be running smoothly, you should. Design a diagram of the fence area at first. Nearby the AC outlet, set the boundary with wire and flags, place the. Receiver collar into neck of your dogs.

Please install the system as below steps. Step 1: Mount the transmitter. To make transmitter work properly, you should ensure there is a 110/220.

VAC outlet nearby before mounting it. Place the transmitter at a wall or.

Tree and fixed it with screws. Step 2: Install the boundary flags and Connect the wire.

Connect one terminal of the wire to transmitter firstly, mount the boundary. Flags one by one according to the boundary layout, and make sure the. Wire go through the hole of flags meanwhile.

Until all the flags has been. Mounted properly along the boundary and come back to the transmitter. Please keep the excess wire around the bobbin and connect the terminal. Push the"+"button increase the control range and "-"button for decreasing it. Press the "+/-" button on the transmitter to set the control range.

Comparison table, such as: 10: Distance 0.5 meters will work, the greater the number of offline, the farther the offline distance, the offline distance of 100 files is about 6 meters. Slowly approaching the boundary line, the product will issue a "bi-bi" warning tone, then place the LED test light on the two contact points of the receiver.

The LED lights up to indicate that there is a shock. Do not put the collar on the dog before the electric shock. After the product is tested, it is worn. Firstly, two metal contact probes are assembled on the receiver screw column. The length of the two can be selected according to the length of the pet hair.

There are 4 silicone rubber sleeves, which are placed on the electric shock column to prevent the metal from contacting the dog's skin and protecting the pet. Don't bring too tight, the gap between the belts can slide one finger as well.