Upgraded Wireless Dog Fence Pet Containment System Waterproof Training Collars. Features: -[Wireless Dog Fence] Digital wireless dog fence helps train your dog to develop the habit of living in its own independent space, ensuring your dog stays in the designated area and you don't have to worry about anything when you go out. It can be widely used for dog training at home or field trips -[Smart Fence Area] This electric pet fence system is reliable, safe and can be used for pet training. It completely eliminates the trouble of wiring and easily establishes a safe area for pet activities.With 1-100 level transmitter signal strength and adjustable remote control range. Its remote control range is a circular area with a radius of 82-1620ft, covering an area of 78 hectares. In this large space, your dog can walk around freely and safely -[Rechargeable Transmitter/Receiver Collar] The wireless receiver collar is equipped with high capacity durable battery, rechargeable, and made of IP67 waterproof material, which means your dog can get wet in the grass, mess up the sprinklers, or use this electric dog fence system in the rain. With adjustable TPU straps, the receiver collar supports most sizes of dogs (10-110lbs, neck: 6-26), each receiver comes with 2 sets of metal extended contact probes for dogs with short or long fur, etc -[Working Principle] When the dog is out of the set control range, the system starts automatically and the receiver starts working with a warning tone every 2 seconds. After the third alarm sound, the low level starts static shock and gradually increases the intensity of static shock. If your dog stays outside the designated area, the receiver will give up working after the third cycle automatically shut down to prevent your dog from forming excessive punishment -[Careful design] The receiver works at 3.7V, static electricity, and causes no harm to the dog or hair. The product's wireless design can handle a variety of terrain. A transmitter can support multiple receivers working at the same time.
1 tow 1 for 1 dog, 1 tow 2 for 2 dogs, 1 tow 3 for 3 dogs Warm tips: -Please be sure and read this manual carefully before use. Tighten the metal probe on the receiver -3: open according to the instructions after pairing the receiver and transmitter, turn on the sound / vibration / electric shock mode, LED test light aligned with the metal probe of the receiver -4: Press the + sign of the transmitter to adjust to your estimated distance, start moving outward to the receiver alarm work, if this is your ideal node (far or near, you just press the + sign of the transmitter / - sign to adjust the corresponding), just insert the flagpole here to remind the pet with their own set range.
And so on for other directions (you must first test the distance set before you can wear the receiver to your pet) FAQ: Q:What should I do first when I receive the product? A: the dog in your ideal range area, if the sound of drops or motor dog, is that you set the estimated distance is small, do not worry, just go to adjust the distance of the host press the + key to the dog in the safe area of the receiver no drops or motor can Q: host transmitter I should be installed where the best signal? A:The host transmitter transmit signal will also be affected by the signal of the surrounding walls or debris accumulation, in order to ensure the normal work of the transmitter signal, you are recommended that you should be installed on the outside wall of the house, no cover (do a good job of waterproofing), or can only be installed in the room, then you should install the transmitter as close as possible to the side of the outer wall yard, and increase the host normal setting distance of 20% signal strength Q:What do I need to pay attention to when wearing a dog receiver?